Sena SPH10S User's Guide download pdf (Page 28)

English

SPH10

19. RESET TO FACTORY DEFAULT

SETTINGS

When you try to start an intercom conversation with an

intercom friend who is already having a conference

intercom with other riders or a mobile phone call,

you will hear a low tone double beep signifying an

intercom busy signal. In this case, you have to try

again later.

If your intercom friend goes out of range while having

an intercom conversation, you may hear static noise

and eventually the intercom will be disconnected. In

this case, the SPH10 automatically tries to reconnect

the intercom every 8 seconds and you will hear high

tone double beeps until the intercom is reestablished.

If you don’t want to make a reconnection, tap the Jog

Dial to stop the attempt.

17. INTERCOM FAILURE

18. INTERCOM RECONNECTION

1. To restore the SPH10 to factory default settings,

press and hold the Phone Button for 12 seconds

until the LED shows solid red and you hear double

beeps. You will hear a voice prompt saying

“Factory reset”.

2. Within 5 seconds, press the Jog Dial to confirm

reset. The headset will be restored to factory

setting and switched off automatically. You will

hear a voice prompt saying “Headset reset,

good-bye”.

3. If you don’t press the Jog Dial within 5 seconds,

the reset attempt is canceled and the headset

returns to stand-by mode. You will hear a voice

prompt saying, “Canceled”.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 40 41

No comments

Sena SPH10S User's Guide Page 28