Sena SMH3 User's Guide download pdf (Page 8)

SMH3

Low Battery Warning

When the battery is low, the blinking blue LED in stand-by mode turns to

red and you will hear mid-tone triple beeps and a voice prompt saying

“Low battery”.

Adjusting the Volume Level

You can easily adjust the volume by pressing the (+) Button or the (-)

Button. You will hear a beep when the volume reaches maximum or

minimum level. The volume is set and maintained independently at

different levels for each audio source even when you turn off and on

the headset. For example, once you set the volume for mobile phone

handsfree, it will not change even if you adjust the volume when you

hear Bluetooth MP3 music. So you can always maintain the preferred

optimum volume level for each audio source.

Function Priority

The SMH3 operates in the following order of priority:

(Highest) Mobile Phone

Intercom

(Lowest) Bluetooth Stereo Music

A lower priority function is always interrupted by a higher priority

function. For example, stereo music is interrupted by an intercom call,

and intercom conversation is interrupted by an incoming mobile phone

call.

Fault Reset

When the SMH3 is not working properly or is in faulty status for any

reason, you may reset by pushing the pin-hole reset button on the left

speaker unit. Insert a paper clip into the reset pin-hole and press and

hold the reset button for a second with light pressure. The SMH3 will be

switched off after which time, you have to turn the system back on and

try again. However, this will not restore the headset to factory default

settings.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

No comments

Sena SMH3 User's Guide Page 8