Sena LS100 User Manual Page 44

  • Download
  • Add to my manuals
  • Print
  • Page
    / 48
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 43
44
Appendix C: Troubleshooting
C.1 Power/LED Status Troubleshooting
Problem Cause Action
Power LED does
not light up
Power cable is not
connected
Check power connection
Ethernet cable is not
connected
Check Ethernet cable connectionLink LED does not
light up
Invalid Ethernet cable is
used
There are two types of Ethernet cables: Straight-through cable
and crossover cable. If you are using an Ethernet hub, use
straight-through cable. If direct connection between the LS100
and remote host is used, use crossover cable instead.
ACT LED does not
blink
Invalid IP configuration Check IP configuration parameters
C.2 Serial Console Troubleshooting
Problem Cause Action
Invalid serial cable Be sure to use a serial console cable (null-modem cable) for
serial console
Invalid serial port
configuration of terminal
emulation program
Check serial port configuration of terminal emulation program:
9600 bps, 8 Data bits, No parity, 1 stop bit, Hardware flow
control
Serial console is not
connected
Invalid Console/Data
switch position
Be sure that Console/Data switch position is Console side.
Serial console is
halted for few
seconds periodically
IP mode is DHCP, but
IP is not assigned
If IP mode is set to DHCP but IP is not actually assigned
because of DHCP server failure, serial console is halted for few
seconds at every 20 seconds. Change IP mode to the static IP
mode
Cannot login to
console
Invalid username and/or
password
Use valid username and password. If username and/or
password are lost, perform factory default reset using factory
reset switch. Factory default value of username and password
are both admin
C.3 Remote Console Troubleshooting
Problem Cause Action
The LS100 is not
assigned valid IP
address
Use serial console to assign valid IP address to the LS100Cannot connect to
the LS100 using
telnet
Someone is using serial
console
Exit serial console and retry telnet connection
Page view 43
1 2 ... 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments