13
2.3.1 Using Serial Console
1) Connect the one end of the serial console cable to the serial port of the LS100.
Figure 2-5 Connecting a serial console cable to the LS100
2) Connect the other end of the cable to the serial port of user’s computer.
3) Slide Data/Console switch to Console side.
Figure 2-6 Data/Console switch of the LS100
4) Run a terminal emulator program such as HyperTerminal. Set up the serial configuration
parameters of the terminal emulation program as follows:
9600 Baud rate, Data bits 8, Parity None, Stop bits 1, Hardware flow control
5) Press [ENTER] key.
Comments to this Manuals