Sena LS100W User Manual download pdf (Page 17)

- If group is omitted, shows help screen.

- If group is specified, shows 'set' command

usage of the group.

factorydefault [option] + <CR> Restore factory default values

- if option is omitted, all parameters are set with

factory default values.

- if option='-ip', all parameters except IP settings

are set with factory default values.

If success,

“OK”+ <CR> + <LF>

If error

“ERROR”+ <CR> + <LF>

save + <CR> Save changes If success,

“OK”+ <CR> + <LF>

If error

“ERROR”+ <CR> + <LF>

exit + <CR> Exit without rebooting the device (changes are

not applied)

If success,

“OK”+ <CR> + <LF>

If error

“ERROR”+ <CR> + <LF>

reboot + <CR> Exit and reboot the device None

2.4.1 ‘set’Command

With ‘set’ command, users can configure parameter values of the LS100W for each environment.

Basic ‘set’command usage is as follows:

set group par1 [par2 ...] + <CR>

where,

group = 'ip','host','serial' or 'admin'

par1 par2 ... = configuration parameters. Use * to keep a parameter's value

The ‘group’is the category where the parameters should be entered. For example, if users want to set

parameters related to the IP configuration, use set command as shown in the Figure 2-8.

> set ip static 192.168.1.100 255.255.255.0 192.168.1.1

Figure 2-8 IP configuration example screen

In the above example, the first parameter ‘ip’ indicates that the following parameters are IP

configuration parameters. The second parameter ‘static’indicates that the LS100W will use static IP

address of the third parameter ‘192.168.1.100’. The fifth parameter indicates the subnet mask and the

next indicates the default gateway IP address.

If users want to change only one of the parameters of the group, users can omit trailing parameters

and/or can use ‘*’to keep a parameter value. The screen below will show how to change subnet mask

only without changing IP address and gateway IP address.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 49 50

No comments

Sena LS100W User Manual Page 17