Sena LS100W User Manual download pdf (Page 18)

> set ip static * 255.255.0.0

Figure 2-9 Changing only one parameter value example

Command usage of ‘set’will differ depending on the groups. Each ‘set’command usage of the group

can be found using ‘help group’command. For example, if users want to know how to use ‘set’

command to configure IP configuration, typing ‘help ip’+ <CR> will show ‘set’command usage for the

IP configuration as shown in Figure 2-10.

> help ip

set ip ipmode par1 par2 ...

- ipmode: static=Static IP / dhcp=DHCP / pppoe=PPPoE

- parameters:

if ipmode = static,

par1 = IP address,

par2 = subnet mask,

par3 = gateway

if ipmode = dhcp,

no parameters required

if ipmode = pppoe,

par1 = PPPoE username,

par2 = PPPoE password

Figure 2-10 Help screen example

Note:

The changed values will not take effect until ‘save’and ‘reboot’commands are invoked. For more

details, please refer to section 2.4.5 ~ 2.4.7.

2.4.2 ‘get’Command

With ‘get’command, users can view the current parameter values and status of the LS100W. Basic

‘get’command usage is as follows:

get [group] + <CR>

where,

group = 'ip','host','serial' , 'admin' or 'status'

- If group is specified, shows settings of the group.

- If group is omitted, shows settings of all groups.

The group means the category where parameters belong to as like ‘set’command. For example, if

users want to view parameter values related to IP configuration, get command as Figure 2-11

can be used.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 49 50

No comments

Sena LS100W User Manual Page 18